Any problems or damage caused by the installation are not covered by the warranty.Īlso, please note, that before packing and shipping the printer for repair, this add-on has to be fully uninstalled. Please note that you are installing this add-on at your own risk. If you feel uneasy about messing with the power cables (although this step is actually not hard at all), feel free to skip it. Some of the steps are optional, for example, the power switch relocation. In total, it shouldn’t take more than 30-40 minutes even at a relaxed pace. While it makes the MINI+ stand taller, trading width for height is usually a good tradeoff, unless you keep your printer in a short rack or shelf.īest of all, the assembly is quite easy and only needs a few pieces of extra hardware. Probably the biggest improvement over the vanilla MINI+ is that with the MINI Base, you don’t need extra space for the filament holder and the PSU, as both the spool and the “brick” are now stored under the printer.
0 kommentar(er)
